660M-T1 - Fluke 660-T1 Instruments - I/F Module, Patch Cable, Tap Box

660M-T1 - Fluke 660-T1 Instruments - I/F Module, Patch Cable, Tap Box...

Fluke 660-T1 Instruments - I/F Module, Patch Cable, Tap Box Simple Type: Instrumentations

For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.

General

AC Recharge Input: 117 V ± 15% 50/60 hertz. Power cord furnished.230 V ± 15% available
Accuracy: Depends only on crystal oscillator frequency in “Exposure Rate” mode (see “Calibration” above). Accuracy of readout unit not applicable in “Exposure” mode. See probe specs for system measurement accuracy.
Battery Charge Time: 10 hrs to full recharge at 20°C (instrument “OFF”). Built-in recharging circuit automatically switches to “trickle charge” after 10 hrs to avoid battery damage.
Battery Complement: One 67.5 V, collecting potential (shelf-life) and 4 rechargeable 1.25 V “D” size batteries for instrument power.
Battery Life: 6 hrs between charges at 20°C with normal usage. Automatic shut-off when charge drops below usable level.
Calibration: Not necessary. Response depends on frequency of internal crystal oscillator (± 0.01% from 10° to 40°C).
Controls: Function Switch - Selects off, total exposure or exposure rate modes.; Reset switch - For use in total exposure mode-selects run, stop or reset.; Intensity Knob - Controls readout brightness.
Range: 3 decade auto ranging and auto indicating including proper decimal placement and proper measurement units. See probe specifications for specific ranges.
Size: 5-½ by 8-½ by 4-½ inches high (13.9 by 21.5 by 11 cm).
Weight Approximately: 7 lbs. Shipping weight: Complete system with two probes - Approximately 30 lbs.